Assembly instructions
Assembly time: 5-10 minutes
Step 1
Connect the 10 arch pieces together to form the arch
Arch assembled:
Step 2
Carefully unwrap the LED band from its holder roll.
Starting from the end without the USB plug, peel back the protection film 5-10 cm.
Choose either end of the plastic arch you have just assembled, count about 4 V cutouts and start applying the LED strip in the middle of the arch.
Press the LED strip firmly against the plastic arch, peel another 5-10 cm and slowly stick the whole LED strip, ensuring the whole surface area of the sticky side is firmly stick on the arch.
LED Strip assembled:
Step 3
Insert the glare guards through each end of the arch, in the slots.
We recommend 2 glare guards on either side - but it is up to you.
You can easily cut the glare guards to the desired length using a pair of scissors.
Step 4
Insert each side of the arch into a foot.
For the side with the USB plug, insert the plug through the hole in the foot and then insert the arch itself. Tidy up the USB cable using the cutout guides under the foot: you can make your USB plug exit on either 4 sides.
Step 5
Insert one end of a strip securing clip into the inner slot of the arch and press the other end until you hear it click onto the opposite inner slot. We recommend using 1 clip per arch segment. This ensures the LED strip will stay secured to the arch over the long term.
Assembly completed: Repeat for each segment of the ARCHLED.
